dated October 2, 2011 (Sun)
It was Sunday already, yet there was still no electric current. So, we waited…………………….and waited………………. and waited………………. and waited………………. and waited………………. and waited………………. and waited………………. and waited………………. and W-A-A-A-A-I-I-I-T-E-D until Beeeeeeeeeeeeeeeeeeeeeng! The water motor rang and I was just so gleeful because current was already back!
F. PCB Drilling
Moving on with the PCB, we’re left with the one final thing – the drilling part (Yeebah!) The drilling was about bearing holes based from the standard design. My cousin, Joshua bore two holes to demonstrate the proper way of drilling then afterwards, when I knew how to do it, I took my turn. I felt both excited and nervous drilling. Of course while drilling, I had to make sure that all the components’ connecting wires would fit into their respective holes that I bore. Julius came that moment so I made him bore the rest of the other holes. üü
Drilling
Drilling
 |
| Drilling |
 |
| PCB after Drilling |
 |
| PCB after Drilling |
 |
| PCB after Drilling |
 |
| PCB after Drilling |
 |
| PCB set for Soldering |
0 comments:
Post a Comment